LFG-50 Low-Frequency Generator, when operated in conjunction with a receiver, can be used for locating as well as tracing underground metal communications, such as any cables with metal cores as well as metal pipes. In addition, it provides operator with a quick detection of short circuits on cables as well as with an identification of a cable in a bunch.
LFG-50 is a 50 W low-frequency generator with ability to inject a signal of three frequencies via direct connection to an object or via internal transmission loop antenna, which is built-in a cover lid. Basic frequencies are 491; 982 and 8440 Hz. There are options of using a single-frequency or multi-frequency signals at the output.
The power of LFG-50 output signal can be adjusted up to 50 W with 2.5 W steps. This signal can be transmitted constantly or broken into separate blocks of 50 % duty cycle with 1 s repetition rate.
A load matching is made automatically. Main parameters, such as output power, load impedance, selected frequency are shown on OLED display. If a load is higher than 1000 Ω LFG‑50 automatically switches into output voltage setting mode. The output overload protection will trip, when operating on short-circuit loops (lower than 0.5 Ω).
Portable and lightweight
Moistureproof and dustproof case
Advanced LiFePO4 internal battery with fast charging option
High-contrast graphic OLED display
Operating frequencies can be changed upon request
Internal transmission loop antenna
Automatic load impedance matching
Ability to work with energized 0.4kV cables (inductive connection)
Traser PT-14 designed for fast and accurate searching for power cables and other communications, identification of coating defects and the depth, followed by mapping.